how to wire an XLR to an RCA connector

How To Wire An XLR To An RCA Connector with 2 Ways

Though it is not recommended to wire an XLR to an RCA connectors, it becomes an option when your audio device may have an XLR output while your pre-amp has only an RCA input. That’s why we come with the idea on how to wire an XLR to an RCA connector you may need to know and apply.

In this regards, we two options to inspire you how to do that. Those are by converting XLR to one RCA cable and converting XLR to Tow RCA cable.

In fact, if there is another option to help you do with it, well, you had better take the alternative choice. If not, then you must stay with us to for less than ten minutes to find out the way of wiring an XLR to an RCA connectors.

Consider the explanation below:

Wiring An XLR to An RCA Connector By Converting XLR To One RCA Cable

Wiring an XLR to an RCA connector by converting XLR to one RCA cable can be done by connecting a 3-pin XLR to one RCA. This kind of wiring is similar to connecting an XLR to a 1/4” plug. In this case, there are two methods to follow.

First, connect the first pin and the third pin to RCA sleeve and second pin to RCA tip. However, be careful about doing this setup since you will likely make a ground loop. Since the first pin and the third pin have the different cables from the differing resistance, there will be a noise and an audible hum as a result. Well, this is just a common problem.

Second, the positive and shield of XLR must be connected together. Do this either at the XLR end or at the RCA end by soldering a link between the first pin and the third pin as well as the third of XLR. This second method is considered better to prevent noise and ground loops. Further, grounding the third pin will not complete anything. The downside is the fact that you will have a risk about the output signal that might misbehave if ground this pin.

Wiring An XLR to An RCA Connector By Converting XLR To Tow RCA Cables

The next way on how to wire an XLR to an RCA connector is converting XLR to Tow RCA cables. Check out whether your XLR comes with a stereo signal or not. If so, you should split the signal into the left and right side of RCA connectors.

In this case, there are two steps you can perform. First, wire the second pin of XLR to the tip of one RCA plug and the third pin of XLR to the RCA tip of the other RCA plug. The second step requires you to connect the first pin of XLR to the sleeve of both RCA plugs.

Overall, it is just a simple process of wiring an XLR to an RCA connector. However, you must be careful since it can produce noise and hum to your system if you don’t do the process carefully. Basically, there is no benefit of wiring an XLR to an RCA connectors. Instead, if you are doing so, you can remove the benefits of the balanced audio. In short, it is best to avoid wiring XLR to an RCA cables unless you must do it. In the other words, if there are some other options, this wiring is not pretty recommended.

However, the choice is definitely on your both hands. If you find this helpful, don’t hesitate to share with your friends.

We hope that information about how to wire An XLR To An RCA Connector above can inspire you all.

Leave a Reply

Posting....